Dell PE2950 Third Party Rail Kits

Dell redesigned the rail kits for the PE2950, adding brackets to the ends which allow installation into round or square hole racks. The brackets actually spin around for both scenarios.

Unfortunately, these rails are not compatible with several of the third party racks and even cause problems with older Dell enclosures. The depth range of the rail kits is not always compatible with these racks. Also, the size of the brackets can conflict with the rack especially if the posts are a ā€œCā€ channel.

The rather large cable management arm will not allow the doors to close on a lot of enclosures as well.

If the Dell rails are not compatible with your racks, take a look at other sliding and non sliding rail kits available.

Leave a Reply

You must be logged in to post a comment.